CRAFTSMAN Table Saw Crank Hand Wheel w/ screw (reinforced) for some 113 models

Description

I have added an extra 1/4" thick tapered copper ring to reinforce the shaft from cracking
. This is my solution to these handles from cracking/braking. The last picture shows the ring before I added black tape. The ring is molded/tapered and then glued on. I have tested this reinforced handle for over a year on all my table saws that I process.
This is only for one handle, Was removed from model # 113.298762, but should other models.
Good condition item.
Fits Craftsman 10" model 113.XXXXXX with a 1/2" flat sided shaft.
Will
not
fit Craftsman 315.XXXXXX series saws, they have a 12MM shaft (smaller), also may
not
fit Craftsman 113.xxxxxx 8" or 9" models, please check shaft size.
Some of the main reasons that your handles crack are as follows: lack of lubrication on internal parts, corrosion on internal parts, not releasing the angle lock down handle before trying to change the angle of the blade. over turning the handle at the end of travel,