NEW Motor bearing for Craftsman 1.5HP motor, TH0112, TH0208, M1110211

Description

(1) bearing for shaft side of motor
The last three pictures show samples of motors that these will fit.
Selection guide
RS / Double rubber seal - Good sealing effect, low rotational resistance and medium temperature resistance.
Z / Double metal seal - Medium sealing effect, no rotational resistance and higher temperature resistance.
These are the double metal seal, better that the double rubber seal
Will fit a Craftsman 1 1/2 HP motor # TH0112, TH0208, M1110211 on the shaft side.
Some of motors are on the following Table saws:
315.228310
315.228390
315.228410
315.228490
315.228510
315.228590
315.248200
These motors have different size bearings on each side. This list is only for the bearing on shaft side (where the pulley is attached)
I have replaced many of these bearings. The shaft side is the bearing that collected saw dust from cutting wood. Usually this is the only bearing that needs to be replaced.
Motor Armature Bearing Set. (for the motor armature not the blade arbor)
bearing is 17mm ID 40mm OD and 12mm wide.
Not for 113 series saws.